Header
Lameschmillen
Buttons
Barn
I'm equipping the barn as a garage. At the moment all the
equipment is in place, but I still have to finish the electrical
provision and build storage shelving and worktops.
Then the grand tidy-up -
as you can see, it's a
mess right
now 
The hard pipe carries compressed air. Electrics
are 3-phase.
I'll take single phase drops as necessary.
Home-built engine lifter and heavy assembly table.
Bike lift and small projects
table - this one's on wheels
for
convenience.
Oxy-acetylene, oxy-propane and
MIG welder.
2 more engine lifters. I'm
going to rebuild one
of them into
a
bike table. I frequently use the pallet lifter instead of the
bike lift because it's easier.
Exercise machine, just in case I
run out of beer
And a 4-ton vehicle hoist.
At the time of writing
I'm
rebuilding the rear brakes on the van.
As you can see, a lot of tidying
up to do, shelving to
build, wiring to
complete, but we're getting there.